Using For The First Time - brennenstuhl Jet-Light 2 x 18 W FL-18 Instructions D'utilisation

Jet-Light 2 x 18 W, FL-18
6 Operation and assembly
Please note the following information, particularly the safety information, in order to avoid operating
errors and possible defects.
7

Using for the first time

Assemble the Jet Light as shown in the diagram:
IMPORTANT: Check all the screw connections before using for the first time.
8 Changing the tubular lamps and the starter
DANGER:
Remove the plug from the mains before opening the lamp!
Allow the Jet-Light FL-18 to cool down before touching it (at least 15 minutes).
Touching it while hot could cause burns. Use only 110 V – 130 V starter!
Step Procedure (tubular lamps)
1 Unscrew the protective cover
2 Remove light bulb
3 Remove distance piece
4 Slip distance piece over new lamp
5 Insert new light bulbs applying light pressure until they lock into place
Replace protective cover
6
Ensure that the seal between the housing and the protective cover is
correct
Step Procedure (starter)
1 Unscrew the protective cover
2 Gently twist the starter to the left and pull out (bayonet fitting)
3 Insert the starter and lock into place by gently twisting to the right (bayonet fitting)
Replace protective cover
4
Ensure that the seal between the housing and the protective cover is correct
Operating instructions
3
4
Stand: FL-06-2011_K