Operation - Hitching And Unhitching - Enduro EMSOSFL Manuel D'utilisateur

Press at the same time, during at least three seconds, the two buttons for disengaging the motor powered
rollers (Fig. 13J). The blue LED (Fig. 13H) will blink fast during these three seconds and every second there will
be a beep. This warns you that the system will be activated!
After these three seconds the motor powered rollers will be released from the tyre and the blue LED will
illuminate constant, now you can release the two buttons. When the motor powered rollers are completely
disengaged you hear a short beep, the blue LED will switch off and the system is ready for transport.
After manoeuvring, deactivate the manoeuvring system by moving the slide switch of the remote handset (Fig.
13A) down (Position "0"). The power LED (Fig. 13Q), the manoeuvring system LED (Fig. 13V) and the
communication LED (Fig. 13H) on the remote handset will turn off. Store remote handset in a safe place (out of
reach of children or other unauthorised people).
Turn off the battery power isolation switch.
For the use of the individual autoSteady system (for example to turn the corner steadies in, or to turn one or
more corner steadies further down with the individual operation), you can switch the remote control from
manoeuvring system use to autoSteady use.
Turn the remote Handset on by sliding the slide switch (Fig. 13A) down (autoSteady position). The green LED
(Fig. 13H) and the red LEDs (Fig. 13Q and 13U) on the remote handset will now light up continuously.
The autoSteady system can now be used as described in the standard user manual for the autoSteady system.
NOTE: The leveling system of the manoeuvring system is not available when using the individual autoSteady
system. The automatic leveling system only works via the Finding Level function of the manoeuvring system.
OPERATION – HITCHING AND UNHITCHING
It is possible to position the caravan's hitch exactly over a stationery car's tow ball using the manoeuvring
system. But please be very careful!
Use the button controls on the remote handset to bring the hitch of the caravan to the car. The soft start
technology allows you to locate the tow-ball of the car by centimetre. It is better reach the tow ball with several
short "trips" rather than trying to do it in one "trip".
WARNING: When the buttons on the remote handset are released, the caravan will slowly
stop after 0.5 second and continue to move about 6cm (depending on final speed). When
the buttons of the remote handset are released when the system is still in the "soft start"
stage (slowly speed up), the caravan will stop immediately.
When the hitch is right above the tow ball of the vehicle, lower the hitch to the ball and engage in the normal
way using the jockey wheel.
Release the rollers from the caravan's tyres. You cannot tow the caravan with the drive
units are engaged! Before you start driving always make sure that the both drive units are
fully disengaged!
Trying to drive away with the drive units still engaged, will damage the manoeuvring
system, your caravan tyres and strain your tow vehicle!
®
EN EM505FL 48
DURO
Ref: EM505FL-UM-TKI-0119-Rev.A.