Before First Use; Adding Salt - Zanussi ZDF22002WA Notice D'utilisation

The programme marker must be in
1. Press and hold
position.
2. Release when
3. Turn the knob counterclockwise until the programme marker is in
• The indicator
4. Press to change the setting.
• The indicator
5. Turn the knob to
CAUTION! If children have access to the appliance, it is advised to deactivate AirDry as
opening the door may pose a danger.

BEFORE FIRST USE

1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance.

ADDING SALT

Before the first use, put one litre of water in the salt container.
CAUTION! Water and salt can come out of the salt container during filling. To prevent
corrosion, start a programme immediately after filling the salt container.
10
position.
and simultaneously turn the knob counterclockwise until the programme marker is in
and Delay start to flash.
is on = AirDry is activated.
is off = AirDry is deactivated.
to confirm the setting.
position.
Do not use detergent and do not put dishes in
the baskets.
After starting the programme, the appliance
recharges the resin in the water softener for up to 5
minutes. The washing phase starts only after this
procedure is complete. The procedure is repeated
periodically.