Operating Times; Operation - Wolf Garten Accu BS 60 Mode D'emploi

Masquer les pouces Voir aussi pour Accu BS 60:
Table des Matières

Publicité

Safety instructions
4. fter cutting:
• Maintenance and cleaning work on the device may only be executed when the motor is not running.
• Clean and lubricate the blades (with Vaseline) after each cutting.
• Repairs to the device may only be carried out by WOLF service centers and authorized repair centers.
• Chargers that have become wet may not be plugged into an electrical outlet until they are dry. Otherwise
the shears should be charged after each trimming (only in a dry room.
lways store the shears in a dry room out of the reach of children in such a way that the cutting head is protected.
5. Dispose of batteries in an environmentally responsible manner (for battery replacement see „maintenance"):
• Wolf battery packs are nickel cadmium rechargeable batteries. They are the most suitable for supplying
energy to mains independent electric devices according to the current state of the art. Nickel cadmium cells
are harmful to the environment if they are incinerated with other household garbage.
• WOLF Garten would like to encourage environmentally friendly consumer attitudes. Working together with
you and WOLF dealers we guarantee the acceptance and recycling of used batteries.
6. Charger
• The charger may only be used in dry rooms.
• Unplug cable connections only by pulling on the plug. Pulling on the cable could damage cable as well as
plug and electrical safety could not be guaranteed.
• Never use the charger if cable, plug, or the device itself have been damaged through external influence.
Bring the charger to the nearest repair shop.
• Under no circumstances should you open the charger. In case of a malfunction take the device to a repair shop.

Operating times

Please convider the individual country spezification.

Operation

Charging (figure B1)
The shears must have been charged for ca. 30 hours before their first use.
For charging - plug the charger in a 230-volt C outlet and plug the charger plug into the charge
socket of the rechargeable shears.
ttention! Only use the charger in dry rooms!
Please note:
• In the interest of long battery service life, the device should not be connected to the charger
longer than is necessary.
• The battery only reaches its full performance after multiple charge and discharge cycles.
• The rechargeable shears should not be charged prior to long periods when it will not be used,
and it should not be charged intermittently in winter.
• The charging time for a completely discharged battery is between 24 and 30 hours.
djusting the cutter head (figure B2)
Slide the lock button up (1) and then turn the cutter head to the desired position (2). Release the
button (1) and check whether the cutter head is locked in place.
Please note:
• The cutter head can be locked in five positions
Powering the shears on / off (figure B3)
1. Push the switch (1) forward and hold it
2. Press button (2)
3. Release switch (1)
4. Power off shears: Release button (2)
ttention! Please follow the safety instructions!
(90° « 45° « 0° » 45° » 90°)
12
.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Accu 8 em7085 095

Table des Matières