INSTALLATION
INSTALLATION
9.4.3 Drilling holes in the wall
You can use the mounting bracket as a template for the holes to
be drilled.
» Position the mounting bracket on the wall observing the
minimum clearances (see chapter "Installation/Installation
location") and mark the holes to be drilled.
» Ensure that the appliance can be mounted to the wall
horizontally. Level out any unevenness in the wall.
9.4.4 Fixing the mounting bracket to the wall
Select fixing materials according to the load-bearing capacity of
the wall.
» Fix the mounting bracket to the wall with suitable rawl plugs
and screws.
30
|AUK
287974-38519-9032.indb 30
9.4.5 Hooking the appliance into the mounting bracket
Hook the appliance by its slots at the back onto the wall mounting
bracket tabs.
» Position the appliance on the lower wall mounting bracket
first. Insert the tabs of the wall mounting bracket into the
slots where the appliance back panel and the floor plate
meet.
» Tilt the appliance towards the wall until the upper hooks of
the mounting bracket click into the appliance.
9.4.6 Inserting the spring pins
» Open the doors of the appliance.
WWW.STIEBEL-ELTRON.COM
19.02.2015 12:05:20