Dc Connection; Safety Instructions For The Dc Connection; Wiring Requirements For The Dc Connection; Dc Connection Process - Ingeteam INGECON SUN 1Play TL M Série Manuel D'installation

DC connection

10. DC connection
This chapter explains the requirements and process for wiring the DC wiring to the unit.
Read carefully before starting the connection process.

10.1. Safety instructions for the DC connection

Make sure there is no voltage present on the unit before starting the connection.
Do not switch on the power to the unit until you have successfully made the rest of the connections
and the unit is closed.
Ingeteam accepts no liability for any damages caused by incorrect connection.
Use the personal protective equipment specified in the section "Personal Protective Equipment
(PPE)".
The grounding of the PV array poles is not permitted in these units.

10.2. Wiring requirements for the DC connection

The wiring gage for the DC connection is specified in the following table:
Recommended gage for DC cables

10.3. DC connection process

1. Remove the caps from the connectors.
ABE2011IQM01_B - Installation and Operation Manual
1Play
4 mm
2
Ingeteam
DE
EN
ES
FR
IT
PT
73