Opening And Closing The Housing - Ingeteam INGECON SUN 1Play TL M Série Manuel D'installation

Ingeteam

6.3. Opening and closing the housing

To install the equipment it is not necessary to open the housing unless you wish to modify the ground
connection or install an accessory.
To access the inside of the unit open the cover of the housing by removing the four front screws.
After making the different connections explained in the sections below, close the unit before starting it. To close
the housing, tighten the aforementioned screws, applying a torque of 6 Nm.
Check that the unit is correctly closed before starting up the unit.
66 ABE2011IQM01_B - Installation and Operation Manual
Installing the unit