Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Wall mounted winch >ALPHA<
English
Inspection- and Maintenance Instructions
Safety Instruction
Before carrying out inspection and maintenance works ensure the winch is unloaded.
Inspection intervals
daily
quarterly
annually
1)
for example by Pfaff-silberblau service department.
The working life of the winch is limited, wearing parts have to be replaced in
good time.
Operating material / recommended lubricant
Recommended lubricant for all lubricating points:
Multipurpose grease acc. to DIN 51825 T1 K 2 K
Waste lubricant has to be disposed according to legal regulations!
Operating failures and their causes
failure
In unloaded state, it is diffi-
cult to turn the crank
Load is not held
Brake does not release,
load may only be lowered
with high expenditure of
force
Disposal
After having placed out of service, the parts of the hand winch have to be recycled or
disposed according to legal regulations!
technische Änderungen vorbehalten
Maintenance-, Inspection Works
Visual examination of rope hook (carrying device)
Function of the winch
Function of brake
Lubricate drive gearing
Lubricate crank-handle gearing
Check the brake disc for wear (replace if thickness is < 2,0 mm)
Check the safety spring crank for brake function and wear
Check and service rope for wear according to DIN 15020 page 2.
Check the fixing screws are tight.
Check all parts of the winch and crank for wear and, if necessary, replace and grease
defect parts.
Re-lubrication of the safety spring crank only by authorised personnel
Only use the grease recommended by us.
Check Name-plate for legibility
Arrange for an examination by a competent person *
cause
Lubricant in bearing points is
missing.
Dirt or something similar has
accumulated in the bearing.
Winch was distorted during
mounting
Wrong coiling of the rope
winding direction for lifting was
not correct,
The brake is worn-out
Too light load
Brake discs or brake mecha-
nism are distorted.
design changes under reserve
04.04.013
)
elimination
Execute maintenance works
Check the fixing.
Is the mounting surface even, are the screws tight-
ened correctly?
Lay the rope correctly (see page Fehler!
Textmarke nicht definiert. )
Check brake parts and replace worn-out parts.
Replace the safety spring crank.
The load has to be at least ca. 20 kg resp. 50 kg
Release the brake by slightly striking against the
crank arm with the flat of the hand in lowering di-
rection
changements techniques sous réserve
1)
12
Publicité
Table des Matières
