Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Wall mounted winch >ALPHA<
English
Vario-Crank (Special design)
The variable crank is available as special design for all >ALPHA< winches.
The length of the variable crank arm is adjustable. This enables to adept the length of the crank arm to the
load.
A
Nr.
1
200
2
250
3
320
The crank arm with handle may be detached from the winch.
Detaching the crank arm:
Loosen the adjusting screw
Pull the crank arm via the safety ball out of the guiding (expenditure of force is required)
Store the crank arm
Pay attention to freedom of motion
Slightly tighten the adjusting screw
Fixing the crank arm:
Loosen the adjusting screw
Put the crank arm into the guiding; strongly push over safety ball
Push the crank arm into the required position
Re-tighten adjusting screw
Pay attention to freedom of motion
When pulling or pushing the crank arm makes sure that, there is enough free space. Pulling or pushing
with force may cause accidents.
Adjustment
Loosen the adjusting screw
Bring the crank arm into the required position
Re-tighten adjusting screw
Before each using, check firm seat of the crank arm
technische Änderungen vorbehalten
suitable for
300 kg
500; 750 kg
1000 kg
design changes under reserve
04.04.013
changements techniques sous réserve
11
Publicité
Table des Matières
