Ibiza Light 9BEAM-MINI Manuel D'utilisation page 3

Features
• 16 / 24 / 48 DMX channels
• 9x 10W RGBW LED
• Extra long life CREE LEDs (>50,000 h)
3 x 3 zones
•
• Narrow beams
• DMX, stand-alone, master-slave and show modes
• Built-in music controlled programs
Pulse & Strobe effects
•
Electronic dimmer 0-100%
•
• Suitable for wall, truss or floor mounting
Specifications
Power supply .................................................................................................. 100-240Vac 50/60Hz
Consumption ................................................................................................................. 140W max.
Fuse ............................................................................................................................................. 3A
Light source .............................................................................................. 9x 10W RGBW CREE LED
Tilt ......................................................................................................................................... 0-185°
Pan.......................................................................................................................... Infinite rotation
Beam angle ................................................................................................................................... 5°
Dimensions ....................................................................................................... 298 x 278 x 185mm
Weight ..................................................................................................................................... 4.5kg
Mounting
ORIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIGGING
The LED moving head provides a unique mounting
bracket assembly that integrates the bottom of the base,
the included 'omega bracket' and the safety cable rigging
point in one unit (see the illustration on the right).When
mounting this fixture on a truss, be sure to use an
appropriate clamp with the included omega bracket using
a M10 screw fitted through the center hole of the 'omega
bracket'. As an added safety measure, be sure to attach
at least one properly rated safety cable to the fixture
using one of the safety cable rigging points integrated in
the base assembly.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX connector configuration
Termination reduces signal errors. To avoid signal transmission problems and interference, it is always advisable to
©Copyright LOTRONIC 2016
COMMON
DMX +
INPUT
DMX-
9BEAM-MINI
Resistance 120 ohm
1/ 4w between pin 2
(DMX-) and pin 3
(DMX+) of the last
fixture.
Page 3