Bosch PAM 220 Notice Originale page 30

30 | English
"1. SPR": Storing the Spring Angle
The spring angle can be stored as follows:
– Open the fold-out leg and base leg until the desired spring angle is
shown on the display.
– Measure the spring angle if it is unknown. To do so, place the workpiece
you want to measure between the fold-out leg and the base leg.
If measurement is not possible with the measuring tool on especially
narrow or small workpieces, use auxiliary equipment, e.g. a bevel, and
then set the angle on the measuring tool.
Press button 7 to store the measured spring angle for the compound mitre.
"SPR" and the current angle will appear on the display.
"2. CNR": Storing the Corner Angle
1 609 92A 0GC | (24.2.14)
SPR
CNR CNR
SPR
Bosch Power Tools