Bosch PAM 220 Notice Originale page 29

English | 29
Press the "MTR" button 8. As long as you hold down the "MTR" button 8,
the calculated horizontal mitre angle "MTR", which has to be set on the mi-
tre saw, will be displayed. At the same time, the "MTR" indicator will light
up in the display.
Note: The calculated mitre angle "MTR" can only be taken over for chop
and mitre saws, for which the setting for vertical cuts is 0°. When the set-
ting for vertical cuts is 90°, the angle for the saw must be calculated as fol-
lows:
90° – indicated "MTR" angle = angle to be set on the saw.
Measuring "Compound Mitres"
"Compound mitre" measurement ("Compound MTR") is used to calculate
horizontal and vertical mitre angles when two workpieces with multiple
angles (e.g. crown mouldings) have to join precisely.
First measure the spring angle (SPR) and the corner angle (CNR). The
measuring tool will then calculate the mitre angle (MTR) and the bevel
angle (BVL).
SPR
CNR
Carry out the worksteps exactly in the given sequence.
Bosch Power Tools 1 609 92A 0GC | (24.2.14)