Bosch PAM 220 Notice Originale page 24

24 | English
Digital Angle Measuring Device
Operating temperature
Storage temperature
Batteries
Operating time, approx.
Automatic switch-off after approx.
Leg length
Weight according to EPTA-Procedure 01/2003
Dimensions
The measuring tool can be clearly identified with the serial number 13 on the type plate.
Assembly
Inserting/Replacing the Batteries (see figure A)
Using alkali-manganese or rechargeable batteries is recommended for op-
eration of the measuring tool.
To open the battery lid 15, press the latch 14 and remove the battery lid.
Insert the batteries/rechargeable batteries. When inserting, pay attention
to the correct polarity according to the representation on the inside of the
battery compartment.
When the battery low indicator b is indicated the first time in the display,
measurements can be made for only about 1 –2 hours.
When the battery low indicator b flashes, the batteries/rechargeable bat-
teries must be replaced. Measurements are no longer possible.
Always replace all batteries/rechargeable batteries at the same time. Do
not use different brands or types of batteries/rechargeable batteries to-
gether.
 Remove the batteries/rechargeable batteries from the measuring
tool when not using it for longer periods. When storing for longer
periods, the batteries/rechargeable batteries can corrode and self-dis-
charge.
1 609 92A 0GC | (24.2.14)
PAM 220
– 10 °C ... +50 °C
– 20 °C ... +70 °C
2x1.5 V LR6 (AA)
25 h
5 min
400 mm
0.9 kg
425 x 41 x 58 mm
Bosch Power Tools