Bosch PAM 220 Notice Originale page 27

English | 27
The reading of the angle w between base leg and fold-out leg is indicated in
the display. The required angle v between base leg and leg extension is cal-
culated as follows:
v = 180° – w
If you press the "180 °" button, the angle v (supplementary angle) you are
looking for will be calculated and displayed.
v
w
Measuring "Simple Mitres"
"Simple mitre" measurement is used to calculate the cutting angle "MTR"
when two workpieces with the same mitre have to form an outer angle x°
smaller than 180° (e.g. for skirting boards, banister columns or picture
frames).
x °
When workpieces are to be fitted into a corner (e.g. for floor trimmings),
measure the corner angle x° by applying the fold-out leg and the base leg.
For given angles (e.g. picture frames), open the fold-out leg and the base
leg until the desired angle is indicated in the display.
Bosch Power Tools 1 609 92A 0GC | (24.2.14)