FLORABEST FRM 1200 D3 Traduction Des Instructions D'origine page 40

GB
Observe the noise protection
and local regulations. The
use of the equipment may be
restricted or prohibited on cer-
tain days (e.g. Sundays and
public holidays), at certain
times of day (lunchtimes, night-
times) or in certain areas (e.g.
health resorts, hospitals etc.).
• Switch on the motor accord-
ing to the instructions and only
when your feet are at a safe
distance from the cutting tools.
• Do not use the equipment in
the rain, in poor weather, in a
damp environment, or on wet
grass. Work only in daylight or
with good lighting.
• Do not work with the equipment
when tired, lacking concentra-
tion or under the influence of
alcohol or drugs. Always take
breaks in good time. Take a
sensible approach to the work.
• When working, ensure a firm
stance, particularly on slopes.
Always work across the slope,
never upwards or downwards.
Take particular care when
changing the direction of travel
on the slope. Do not work on
excessively steep slopes.
• Run the equipment only at a
walking pace. Take particular
care when turning the equip-
ment around, pulling it towards
you or going backwards.
• Switch on the equipment care-
fully and in accordance with
the directions in these instruc-
tions. Ensure sufficient distance
between feet and the rotating
blades.
4 0
• Do not tilt the equipment when
starting other than if it is nec-
essary to do so when starting
up in long grass. In this case,
tilt the equipment by pressing
down the handle bar such that
the front wheels of the equip-
ment are raised. Always check
that both hands are in the work-
ing position before returning the
equipment to the ground.
• Do not work without the grass
box or collision guard. Keep
away from the ejection hole at
all times.
Caution! Danger! The blade
continues to run after switch-
ing off.
There is a risk of injury.
• The equipment is not to be lifted
or transported while the motor
is running. Switch off the equip-
ment if it has to be tilted in tran-
sit, when crossing surfaces other
than grass, and when the equip-
ment is being transported to and
from the surfaces to be mowed.
• Always keep the grass ejection
hole clean and clear. Remove
cut material only when the
equipment is stopped.
• Do not leave the equipment un-
attended in the workplace.
• Do not work with equipment that
is damaged, incomplete, or has
been modified without the author-
isation of the manufacturer. Do
not use the equipment with dam-
aged safety devices or screens
or with missing safety equipment
such as deflection and/or grass
collection devices.