Getting Started; Assembly; Using The Vacuum - shark EP780C Manuel Du Propriétaire

Getting Started

a
c
b
d
g e
f
FIRST THING'S FIRST, YOU NEED TO
KNOW WHAT'S IN THE BOX YOU JUST
OPENED:
a Canister Vacuum
b Flexible Hose with Handle
c Upper Extension Tube
d Lower Extension Tube
e Floor Brush
f Combo Crevice/Dusting Tool
g Turbo Brush
4 TOLL FREE: 1-800-798-7398

Assembly

B
A
C
D
Fig. 1
YOUR SHARK QUICK CLEAN CANISTER IS EASY TO
®
ASSEMBLE:
1 P lace your vacuum canister on a level surface
D O NOT plug in the vacuum until it is fully assembled.
2 I nsert the flexible hose (A) into the air intake duct. Push
it in until you hear it "click", indicating that it is locked in
place. (Fig. 1)
3 I nsert the upper extension tube (B) into the handle end of
the flexible hose. (Fig. 1).
4 I nsert the lower extension tube (C) into the upper
extension tube. (Fig. 1)
5 P ush the end of the extension tube into the floor
brush (D). (Fig. 1)
6 T he combo crevice/dusting tool (E) is stored in the back of
the vacuum next to the power cord. (Fig. 1)

Using the Vacuum

Fig. 2
E
Fig. 3
1 T o extend the power cord, pull
it from the rear of the vacuum
to the desired length. (Fig. 2) A
yellow mark on the power cord
shows the ideal cable length.
CAUTION: Do not pull the
power cord beyond the red
mark on the power cord as this
will damage the cord.
2 T o retract the power cord, press
the cord rewind button. (Fig. 3)
If the cord does not fully retract,
pull it out a little and then press
the rewind button again.
WARNING: Always hold the
plug and DO NOT allow to
whip when rewinding.
Fig. 6
Fig. 4
Fig. 5
3 P lug the vacuum into an Manual Suction Control
electrical wall outlet.
The Shark ® Quick Clean Canister
4 P ress the On/Off Button to the vacuum includes a manual variable
"On" position to begin.
suction control on the handle of
(Fig. 4)
the hose. The suction power can
be adjusted by moving the slide
5 P ress the On/Off Button to the
regulator to the desired position.
"Off" position when finished
(Fig. 6) By opening the slide
using the vacuum.
regulator, the suction will be
6 T o store the canister vacuum,
reduced for vacuuming upholstery
insert the clip that is on the
and draperies. With the slide
back of the floor brush into the
regulator closed, you get maximum
slot on the back of the vacuum.
suction for vacuuming carpets.
(Fig. 5)
www.sharkclean.com
English
5