Preparing The Ice Dispenser For Long Storage - Hoshizaki DIM-30AE Notice D'utilisation

ENGLISH
* Instances of high humidity and moisture
increase the risk of electrical short
circuits and potential electrical shocks. If
in doubt, disconnect the ice dispenser.
* Do not pull the power cord in order to
disconnect the ice dispenser from the
feed network.
* To prevent possible electric shock
caused by accidental contact with the
attachment plug, the ice dispenser must
be plugged in tightly.
* Appliance must be positioned so that the
plug is accessible.
* This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety.
* Young children should be supervised
to ensure that they do not play with the
appliance.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the power switch is turned off, wait for
at least 5 minutes before restarting the
ice dispenser to prevent damage to the
compressor.
1. START UP
1) Open the water tap.
2) Plug in the ice dispenser, and turn on the power
switch to start operation.
3) Press the push button and check for proper ice
dispensing action after 30 - 60 minutes.
IMPORTANT
When water supply is off or water pressure is
too low, the ice dispenser will produce no ice
or abnormal ice. Always ensure proper water
supply.
2. ICE DISPENSING
* Press the push button to dispense ice.
* Do not press the push button for more than 5
minutes.
3. PREPARING THE ICE DISPENSER FOR
LONG STORAGE
IMPORTANT
1. T h i s i c e d i s p e n s e r w i l l n o t w o r k a t
subfreezing temperatures. To prevent
damage to the water supply line, drain
the ice dispenser when air temperature is
below zero.
2. When shutting down the ice dispenser for
two or more days, drain the ice dispenser
to prevent contamination in the water circuit
1) Close the water tap. Remove the inlet hose from
the water tap, and drain the hose.
2) Dispense all ice from the storage bin.
3) Turn off the power switch, and unplug the ice
dispenser.
4) A s k f o r d r a i n i n g o f t h e i c e d i s p e n s e r b y
professional qualified personnel.
III. MAINTENANCE
1. CLEANING
WARNING
1. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
maintenance operations, turn off the power
switch and unplug the ice dispenser from
the electrical supply network.
2. Ask a trained service person to clean and
sanitize the ice dispenser water system at
least twice a year and to check and clean
the condenser at least once a year.
3. This appliance must not be cleaned by use
of a water jet.
4. To prevent possible damage, do not clean
the plastic parts with water above 40°C or
in a dishwasher.
[1] Exterior and Ice Station
Wipe the exterior and ice station at least once per
week with a clean, soft cloth. Use a damp cloth
containing a neutral cleaner to wipe off grease or
dirt.
4