Battery Check/Setting On A New Machine - Advance SW900 Instructions D'utilisation

BATTERY CHECK/SETTING ON A NEW MACHINE

WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by qualified personnel only.
According to the type of batteries (WET or GEL-AGM), set the machine battery charger.
Check the batteries for damage before installation.
Disconnect the battery connector and the battery charger plug.
Handle the batteries with great care.
Install the battery terminal protection caps supplied with the machine.
The machine requires one 12 V battery, or two 6 V batteries connected according to the diagram in Figure 1.
The machine can be supplied in one of the following configurations:
a) WET or GEL batteries already installed on the machine
b) Without batteries
According to machine configuration, proceed as follows.
a) WET or GEL-AGM batteries already installed on the machine
1. Disengage the front latch (22) and open the battery and main motor hood (21), then check that the batteries are connected to
the machine with the connector (36).
2. Close the battery and main motor hood (21) and engage the front latch (22).
3. Insert the ignition key (2) on the control panel and turn it to "I" without pulling the drive control lever (8).
If the green LED (4) turns on, the batteries are ready to be used.
If the yellow or red LED (5 or 6) turns on, the batteries must be charged (see the procedure in Maintenance chapter).
b) Without batteries
1. Buy appropriate batteries (see the Technical Data paragraph and the
diagram in Figure 1).
For battery choice and installation, apply to qualified battery Retailers.
2. Disengage the front latch (22) and open the battery and main motor hood
(21).
3. Ensure that the battery connector (36) is disconnected.
WARNING!
The installed batteries may require a specific charging algorithm:
to set the most appropriate charging algorithm for the installed
batteries, always contact a qualified Advance Service Center.
4. Carefully lift the batteries to the relevant compartment, then place them as
shown in Figure 1.
5. Route and install the battery cable as shown in the diagrams in Figure 1,
then carefully tighten the nut on each battery terminal.
6. Place the protection cap on each terminal, then connect the battery
connector (36).
7. Close the battery and main motor hood (21) and engage the front latch (22).
8. Charge the batteries (see the procedure in Maintenance chapter).
INSTRUCTIONS FOR USE
1465374000 - SW900
ENGLISH
BATTERY PLUG
6V
6V
BATTERY PLUG
12V
P100816
Figure 1
11