Pioneer AVIC-N4 Manuel D'installation page 15

Connecting the System
30 cm (12 in.)
Power cord
Violet/White (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system can detect whether the vehicle is moving
forwards or backwards. Connect the violet/white lead to the lead whose voltage changes when
the shift lever is put in reverse. Unless connected, the sensor may not detect your vehicle
traveling forward/backward properly, and thus the position of your vehicle detected by the sensor
may be misaligned from the actual position.
Note
• When you use the ND-PG1 speed pulse
generator (sold separately), please make sure
to connect this lead.
• When you use a rear view camera, please make
sure to connect this lead. Otherwise you
cannot switch to rear view camera picture.
CAUTION
Be sure to use only the supplied extension lead. Use of another
lead could cause fire, smoke and/or damage this navigation
system.
The display unit
Extension lead
(for reverse signal)
Check the position of your
vehicle's backup light (the one that
lights up when the shift lever is in
reverse [R]) and find the backup
light lead in the trunk.
Note
Cords for this navigation system and those for
other products may be different colors even if they
have the same function. When connecting this
navigation system to another product, refer to the
supplied manuals of both products and connect
cords that have the same function.
Yellow/Black (GUIDE ON)
When combining this navigation system with the
other Pioneer audio unit for the vehicle, if the vehicle
stereo has yellow/black leads, connect them to those
leads. In this way, the vehicle stereo is automatically
muted to reduce the vehicle stereo volume when;
— the guidance audio is output.
— the mobile phone is used via Bluetooth adapter.
Connection method
Fuse resistor
5 m (16 ft. 5 in.)
Clamp the backup
light lead.
Clamp firmly with
needle-nosed
pliers.
backup
light lead
Section
03
15
En