Cleanmaxx HL-3202 Mode D'emploi page 19

■ Empty and clean the collecting container after each use (see the "Cleaning the Device
and Accessories" chapter). IMPORTANT: Do not overfi ll the collecting container!
■ Switch the device off after each surface has been cleaned as this will increase the
operating time on each battery charge.
■ Test the wiping attachment on a non-visible spot before using it on sensitive (high-
gloss) surfaces.
■ Do not use the device when it is connected to the mains adapter.
1. Press the On / Off switch (1) to switch on the device. The operating lamp lights up
blue. The normal suction mode is switched on.
2. Press the On / Off switch (1) again to switch to strong suction mode. The operating
lamp lights up red.
(Similar to the one shown)
Use of the Spray Bottle with Wiping Attachment
1. Fill the spray bottle: Unscrew the spray head from the spray bottle and fi ll the bottle
with cleaning agent and water in accordance with the manufacturer's specifi cations.
d
c
(Similar to the one shown)
7. Detach the dirt using the wiping cloth. Note: If necessary, rinse out the wiping cloth
under running water!
8. Suck the cleaning liquid up from the surface using the device.
AFRmVS_DE-EN-FR-NL_A5_V6.indb 19 AFRmVS_DE-EN-FR-NL_A5_V6.indb 19
19
3. Guide the nozzle (4) over the surface to be cleaned from
top to bottom. During use, check whether the collecting
container (5) is full. If this is the case, it needs to be
emptied.
4. Hold down the On/Off switch (1) for around 3-5 seconds to
switch off the device.
5. After each use, you should empty and clean the
collecting container (5) (see the "Cleaning the Device and
Accessories" chapter).
6. Charge up the battery after each use (see the "Charging
Up the Battery" chapter).
2. Place the wiping attachment (a) onto the spray head (b):
To do this, press together the locking lugs on the wiping
a
attachment and plug them into the holder on the spray
b
head. They must fi rmly engage.
3. Stretch the wiping cloth (d) onto the wiping attachment
with the aid of the rubber loops and secure it in place with
the Velcro fastener.
4. Close the bottle again.
5. Move the spray nozzle to SPRAY (spray mist) or STREAM.
6. Spray the cleaning product evenly onto the surface which
is to be cleaned. To do this, press the spray lever (c) of
the bottle.
EN
11.04.2017 10:09:45 11.04.2017 10:09:45