Intended Use - Hilti SID 8-A22 Notice D'utilisation Originale

3.2 Intended use

The product described is a compact cordless impact screwdriver with hex
bit holder for heavy-duty screwdriving in wood.
The following applications are available:
• Driving screws in structural-timber structures with Torx bits
• Drilling holes in wooden structures with auger bits with 7/16" shank
• Driving pull screws in wooden structures with 7/16" hex to ½" square
adapter and sockets
Use the cordless screwdriver only for applications that do not require
a precise/specified torque. Otherwise there is a risk of over-tightening
and damage to the screw or workpiece.
• Use only Hilti lithium­ion batteries of the B 22 series with this product.
• Use only Hilti-approved battery chargers to charge these batteries. More
information is available from your Hilti Store or from www.hilti.group
3.3 Items supplied
Impact screwdriver, operating instructions.
Other system products approved for use with this product can be found
at your local Hilti Store or at: www.hilti.group
3.4 Li­ion battery display
When the Li-ion battery is in use, the charge status can be displayed by
tapping one of the battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is
ready for use.
1 LED blinks, the power tool is not
ready for use.
4 LEDs blink, the power tool is not
ready for use.
Indication of the charge status is not possible while the power tool is
in operation or immediately after operation. If the battery charge status
LEDs flash, please refer to the information given in the Troubleshooting
section.
8 English
Printed: 14.10.2019 | Doc-Nr: PUB / 5293229 / 000 / 02
Meaning
Charge status: 75 % to 100 %
Charge status: 50 % to 75 %
Charge status: 25 % to 50 %
Charge status: 10 % to 25 %
Charge status: < 10 %
The battery has overheated.
The power tool is overloaded or has
overheated.
2153706
*2153706*