Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Trouble or fault
The power tool
doesn't start.
The control switch
cannot be pressed.
Speed of rotation
drops considerably.
The battery is not
heard to engage.
The battery runs low
more quickly than
usual.
10
Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking
gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical
tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local govern-
mental garbage disposal or public health and safety resources for disposal
instructions.
*2153706*
Printed: 14.10.2019 | Doc-Nr: PUB / 5293229 / 000 / 02
Possible cause
The battery is not fitted
correctly.
1 LED blinks: The bat-
tery is too hot or too
cold.
4 LEDs blink: The power
tool was overloaded
briefly.
The forward / reverse
selector switch is in the
middle position.
Low battery.
The retaining lugs on the
battery are dirty.
Very low ambient tem-
perature.
2153706
Action to be taken
▶ The battery must be
heard to engage.
Remove the battery
and refit it.
▶ Allow the battery to
cool down / warm
up to its working
temperature.
▶ Release the control
switch and press it
again after a few
seconds.
▶ Push the forward /
reverse switch to the
left or right.
▶ Remove the battery
and charge it.
▶ Clean the retaining
lugs.
▶ Warm up the battery
slowly to room tem-
perature.
English
13
Publicité
Table des Matières
