Removing The Battery - Hilti SID 8-A22 Notice D'utilisation Originale

2. Push the battery into the battery holder until it engages with an audible
click.
3. Check that the battery is seated securely.

5.3 Removing the battery

1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4 Fitting the belt hook (optional)
The belt hook enables you to attach suitable power tools to your belt. It can
be fitted to allow attachment on the left or right side of the body.
CAUTION
Risk of injury by falling power tools!
▶ Check that the belt hook is fitted securely before beginning work.
1. Fit the belt hook.
2. Attach your power tool to the belt hook.
3. Check that belt hook and power tool are secure.
5.5 Inserting the accessory tool
CAUTION
Risk of injury through use of the wrong type of accessory tool!
▶ Use only accessory tools of the locking type.
▶ Do not use worn or damaged accessory tools.
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the chuck ring forward and hold it in this position.
3. Push the accessory tool into the chuck as far as it will go and then release
the ring.
6 Types of work
ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function
selection during operation.
Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Setting forward or reverse rotation
In the middle position, the forward / reverse selector switch serves as a
safety lock.
10 English
Printed: 14.10.2019 | Doc-Nr: PUB / 5293229 / 000 / 02
2
3
5
2153706
*2153706*