Peg-Perego prima pappa newborn Notice D'emploi page 14

_ Risk of falling: it is dangerous to use the
reclined cradle on a raised surface.
HIGH CHAIR
_ The high chair is designed for children
from 6 months of age up to a weight of
15 kg.
_ Do not use the product as a high chair
until the child can sit up alone. The tray
and its accessories are not designed to
support the child's weight. The tray is not
designed to keep the child in the seat and
does not substitute the safety harness.
_ Make sure the product is placed on a flat
surface.
_ Position the product so that the child is
far from dangers such as electrical wiring,
heat sources and flames.
_ Do not use the product near stairs or steps.
_ Take care not to position the product
near sources of heat or fire, such as gas
hobs, electric heaters, etc.
_ The high chair is designed for use at
tables without the tray. It is suitable for
children from 12 months of age up to a
weight of 15 kg.
A single product which follows the
growth of your child.
_ From 0 to 6 months, a comfortable recliner.
_ From the age of 6 months, a high chair
for eating, playing and relaxing.
_ From the age of 12 months, a high chair
without a tray, for sitting at the table
with the adults.
A single product that follows the growth of your
child:
_ From 0 to 6 months a comfortable baby rocker.
_ From 6 months a high chair for eating, playing and
relaxing.
_ From 12 months a high chair without a tray for sitting
at the table with the adults.
COMPONENTS OF THE ITEM
Check the contents of the packaging. For any complaints,
please contact our Customer Service department.
_ High chair with washable and removable padding, a
double tray, a basket, 2 normal feet and 2 feet with
wheels.
INSTRUCTIONS
1 ASSEMBLY: Open the frame by pulling the two side
levers upwards (fig_a) and fit the side support into its
slot (fig_b).
2 FEET: Attach the feet with wheels to the short tubes at
the rear (fig_a) and the others to the longer tubes at
the front (fig_b).
3 SEAT: Make sure that you do not attach the seat
backwards (fig_a). The footrest must always be on
the side with the longer tubes.
To fit the seat, pull both of the side levers on it upwards
(fig_b) and attach it by putting it on the frame (fig_c).
Ensure that it is properly attached by pushing the
backrest back until it clicks (fig_d).
4 BASKET: Before fitting the basket, remove the side
strips on the supports (fig_a). Attach the basket with
the Velcro at the front and the back (fig_b).
5 Next fasten it with the clips on the side (fig_c). Fig_d
shows a fitted basket.
6 FIVE POINT SAFETY HARNESS: To fasten it, push the
two waist strap buckles (with the shoulder straps
attached) into the leg divider until they click into
position (fig_a). To release it, press both sides of the
buckle and pull the waist strap outwards at the same
time (fig_b). To tighten the waist strap, pull from both
sides in the direction of the arrow (fig_c). To loosen it,
do the opposite. The waist strap can be tightened as
far as the safety stop (fig_d).
7 The shoulder straps of the harness can be set at two
different heights. Partially remove the fabric covering
(fig_a), release the shoulder straps from the backrest
(fig_b) and pull them out from the fabric covering (fig_c).
8 Insert the ends of the shoulder straps in the other
slots in the fabric covering (fig_d) and the backrest
(fig_e), then put the fabric covering back on the
backrest properly.
9 EARLY MONTHS FOOTREST: The high chair is
equipped with a footrest to use when it is in baby
rocker mode. Lift the footrest by rotating it upwards
(fig_a). To fold it away, press the two side buttons
(fig_b) and rotate it downwards (fig_c).
10 FOOTREST: Lower the footrest (fig_a), press the two
side buttons (fig_b) and put it at one of the 3 heights
available (fig_c).
11 TRAY: To fit the tray, pull the central handle
underneath it towards you (fig_a) while at the same
time pushing it all the way into the armrests (fig_b).
To extend or remove the tray, pull the central handle
towards you and adjust it (fig_c). The high chair has
a double tray. The top tray can easily be washed in a
dishwasher.
To remove it, detach it from the lower tray and lift it
up (fig_d).
12 USE WITHOUT THE TRAY: To use the high chair at the
table, remove the tray.
13 ADJUSTING THE HEIGHT: The seat can be set at different
heights. To raise or lower the seat, pull the two levers
upwards (fig_a). Stop at the desired position (fig_b). This
can be done with the child in the high chair.
14 RECLINING BACKREST: The seat can be reclined in 4
positions: for eating, playing, relaxing or sleeping. To
adjust it, raise the handle behind the backrest (fig_a)
and lock it in the desired position (fig_b). This can be
done with the child in the high chair.
15 REMOVING THE SEAT: To remove the seat, put it in
the highest position (fig_a), press the two round side
buttons at the same time (fig_b) and remove it (fig_c).
FOLDING UP: The high chair can be folded up with or
without the seat and/or the tray attached.
16 FOLDING UP THE TRAY: To fold up the tray, pull it
out as far as the red markers nearest to it (fig_a) and
rotate it upwards (fig_b). Fig_c shows the high chair
folded up with the tray attached. The tray can also be
put on the rear tubes of the high chair (fig_d).
17 FOLDING UP THE HIGH CHAIR: To fold it up with the
seat attached, fold up the footrest, lower it to the
lowest position (fig_a), press the levers underneath it
all the way down (fig_b) and at the same time rotate
the seat forwards (fig_c).
18 Pull the levers on the sides of the high chair upwards
(fig_d) while pressing the pedal (fig_e) and fold up
the high chair. The high chair is freestanding when
folded up (fig_f).
19 REMOVABLE COVERS: To remove the covers of the
seat, pull off the upper part of the fabric covering and
- 14 -