Installation And Connection; Earthing Instructions - Panasonic NE-1037 Mode D'emploi

Masquer les pouces Voir aussi pour NE-1037:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 48
Examine your microwave oven
Unpack the oven, remove all packing material, and
examine the oven for any damage such as dents,
broken door latches or cracks in the door. If you find
any damage, notify your dealer immediately. Do not
install a damaged microwave oven.

Earthing instructions

IMPORTANT: THIS UNIT HAS TO BE PROPERLY
EARTHED FOR PERSONAL SAFETY.
If your AC outlet is not grounded, it is the personal
responsibility of the customer to have it replaced with a
properly grounded wall socket.
Operation voltage
The voltage has to be the same as specified on the
label on the oven. If a higher voltage than specified is
used, it may cause a fire or other damages.
Placement of the Oven
1. Place the oven on a flat and stable surface.
2. When this oven is installed, it should be easy to
isolate the appliance from the electricity supply by
pulling out the plug operating a circuit beaker.
3. For proper operation, ensure a sufficient air
circulation for the oven.
Counter-top use:
a. Allow 15 cm of space on the top of the oven,
10 cm at back and 5 cm on both sides.
b. If one side of the oven is placed flush to a wall,
the other side or top must not be blocked.
5 cm
4. Do not place this oven near an electric or gas
cooker range.
5. The feet should not be removed.
6. This oven is only for household usage. Do not use
outdoors.
7. Avoid using the microwave oven in high humidity.
8. The power cord should not touch the outside of the
oven. Keep the cord away from hot surfaces.
NE-1037_EYG.indb
8

Installation and Connection

15 cm
10 cm
- 8 -
Do not let the cord hang over the edge of a table or
work top. Do not immerse the cord, plug or oven in
water.
9. Do not block the air vents on the top and back of
the oven. If these openings are blocked during
operation the oven may overheat. In this case the
oven is protected by a thermal safety device and
resumes operation only after cooling down.
Caution
This appliance is delivered without a plug and must be
installed by a qualified electrician to a 16 A fused
power supply 400 V 3/N/PE 50 Hz. Installation must
conform to local rules and standards. Please refer the
data on the nameplate.
IMPORTANT: The wires in the mains lead are coloured
in accordance with the following:
Green and Yellow: Earth
Blue:
Neutral
A precise assignment of the live wires is not necessary
as the connection is not dependant on phase
sequence. The colour of the live wires may vary.
Use of your oven
1. Do not use the oven for any reason other than the
preparation of food. This oven is specifically
designed to heat or cook food. Do not use this oven
to heat chemicals or other non-food products.
2. Before use, check that utensils/containers are
suitable for use in microwave ovens.
3. Do not attempt to use this microwave oven to dry
newspaper, clothing or any other materials. They
may catch on fire.
4. When the oven is not being used, do not store any
objects other than oven accessories inside the
oven in case it is accidentally turned on.
5. The appliance shall not be operated by
MICROWAVE WITHOUT FOOD IN THE OVEN.
Operation in this manner may damage the
appliance.
6. If smoke or a fire occurs in the oven, press the
Stop/Reset Pad and leave the door closed.
Disconnect the power cord, or shut off power at the
fuse or the circuit breaker panel.
Manufactured by: Panasonic Corporation,
1006 Oaza Kadoma, Kadoma City, Osaka, Japan
Imported by: Panasonic Marketing
Europe GmbH
Contact: Panasonic Testing Centre
Winsbergring 15, 22525 Hamburg,
Germany.
2020/11/25
10:37:16

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ne-1027

Table des Matières