Installation And Connection; Important Safety Instructions - Panasonic NN-E205 Mode D'emploi

Installation and Connection

Examine your microwave oven
Unpack the oven, remove all packing material,
and examine the oven for any damage such as
dents, broken door latches or cracks in the
door. If you find any damage, notify your dealer
immediately. Do not install a damaged
microwave oven.
Earthing instructions
IMPORTANT: THIS UNIT HAS TO BE
PROPERLY EARTHED FOR PERSONAL
SAFETY.
If your AC outlet is not grounded, it is the
personal responsibility of the customer to have
it replaced with a properly grounded wall
socket.
Operation voltage
The voltage has to be the same as specified on
the label on the oven. If a higher voltage than
specified is used, it may cause a fire or other
damages.
Placement of the Oven
1. Place the oven on a flat and stable
surface.
2. When this oven is installed, it should be
easy to isolate the appliance from the
electricity supply by pulling out the plug or
operating a circuit breaker.
3. For proper operation, ensure a sufficient air
circulation for the oven.
Counter-top use:
a. Allow 15 cm of space on the top of the
oven, 10 cm at the back, 5 cm on one
side, and the other side must be
opened more than 40 cm.
b. If one side of the oven is placed flush
to a wall, the other side or top must
not be blocked.
5 cm
Counter-top
4. Do not place this oven near an electric or gas
5. The feet should not be removed.
6. This oven is only for household usage.
7. Avoid using the microwave oven in high
8. The power cord should not touch the
9. Do not block the air vents on the top and
WARNING

Important Safety Instructions

1. The door seals and seal areas should be
2. Do not attempt to tamper with or make any
3. Do not operate this appliance if it has a
4. If the supply cord is damaged, it must be
15 cm
OPEN
5. Only allow children to use the oven without
10 cm
6. Liquids and other foods must not be heated
cooker range.
Do not use outdoors.
humidity.
outside of the oven. Keep the cord away from
hot surfaces. Do not let the cord hang over
the edge of a table or work top. Do not
immerse the cord, plug or oven in water.
back of the oven. If these openings are
blocked during operation the oven may
overheat. In this case the oven is
protected by a thermal safety device and
resumes operation only after cooling down.
cleaned with a damp cloth.
The appliance should be inspected for
damage to the door seals and door seal
areas and if these areas are damaged the
appliance should not be operated until it has
been repaired by a service technician trained
by the manufacturer.
adjustments or repairs to the door, control
panel housing, safety interlock switches or
any other part of the oven. Do not remove
the outer panel from the oven which gives
protection against exposure to microwave
energy.
Repairs should only be done by a qualified
service person.
damaged CORD OR PLUG, if it is not
working properly, or if it has been damaged
or dropped. It is dangerous for anyone other
than a service technician trained by the
manufacturer to perform repair service.
replaced by the manufacturer or its service
agent or a similarly qualified person in order
to avoid hazard.
supervision when adequate instructions have
been given so that the child is able to use the
oven in a safe way and understands the
hazards of improper use.
in sealed containers since they are liable to
explode.
En-1