Installation And Connection; Important Safety Instructions - Panasonic NN-SD278SEPG Mode D'emploi

22L solo EP Eng :19L solo EP Eng
Examine your microwave oven
Unpack the oven, remove all packing material,
and examine the oven for any damage such as
dents, broken door latches or cracks in the
door. If you find any damage, notify your dealer
immediately. Do not install a damaged
microwave oven.
Earthing instructions
IMPORTANT: THIS UNIT HAS TO BE
PROPERLY EARTHED FOR PERSONAL
SAFETY.
If your AC outlet is not grounded, it is the
personal responsibility of the customer to have
it replaced with a properly grounded wall
socket.
Operation voltage
The voltage has to be the same as specified on
the label on the oven. If a higher voltage than
specified is used, it may cause a fire or other
damages.
Placement of the Oven
This oven is intended for counter-top use only.
It is not intended for built-in use or use inside a
cupboard.
1. Place the oven on a flat and stable
surface.
2. When this oven is installed, it should be
easy to isolate the appliance from the
electricity supply by pulling out the plug or
operating a circuit breaker.
3. For proper operation, ensure a sufficient air
circulation for the oven.
5 cm
Counter-top
30/1/08

Installation and Connection

15 cm
OPEN
10 cm
14:51 Page 1
Counter-top use:
a. Allow 15 cm of space on the top of the
oven, 10 cm at the back, 5 cm on one
side, and the other side must be
opened more than 40 cm.
b. If one side of the oven is placed flush
to a wall, the other side or top must
not be blocked.
4. Do not place this oven near an electric or gas
cooker range.
5. The feet should not be removed.
6. This oven is only for household usage.
Do not use outdoors.
7. Avoid using the microwave oven in high
humidity.
8. The power cord should not touch the
outside of the oven. Keep the cord away from
hot surfaces. Do not let the cord hang over
the edge of a table or work top. Do not
immerse the cord, plug or oven in water.
9. Do not block the air vents on the top and
back of the oven. If these openings are
blocked during operation the oven may
overheat. In this case the oven is
protected by a thermal safety device and
resumes operation only after cooling down.
WARNING

Important Safety Instructions

1. The door seals and seal areas should be
cleaned with a damp cloth.
The appliance should be inspected for
damage to the door seals and door seal
areas and if these areas are damaged the
appliance should not be operated until it has
been repaired by a service technician trained
by the manufacturer.
2. Do not attempt to tamper with or make any
adjustments or repairs to the door, control
panel housing, safety interlock switches or
any other part of the oven. Do not remove
the outer panel from the oven which gives
protection against exposure to microwave
energy.
Repairs should only be done by a qualified
service person.
En-1