Installation And Connection - Panasonic NN-GD569M Mode D'emploi

Examine your microwave oven
Unpack the oven, remove all packing material, and examine the oven
for any damage such as dents, broken door latches or cracks in the
door. If you find any damage, notify your dealer immediately. Do not
install a damaged microwave oven.
Earthing instructions
IMPORTANT: THIS UNIT HAS TO BE PROPERLY EARTHED FOR
PERSONAL SAFETY.
If your AC outlet is not grounded, it is the personal responsibility of the
customer to have it replaced with a properly grounded wall socket.
Operation voltage
The voltage has to be the same as specified on the label on the oven. If
a higher voltage than specified is used, it may cause a fire or other
damages.
Placement of the Oven
This oven is intended for counter-top use only. It is not intended for
built-in use or for use inside a cupboard.
1. Place the oven on a flat and stable surface, more than 85 cm above
the floor.
2. When this oven is installed, it should be easy to isolate the appliance
from the electricity supply by pulling out the plug or operating a
circuit breaker.
3. For proper operation, ensure a sufficient air circulation for the oven.
Counter-top use:
a. Allow 15 cm of space on the top of the oven, 10 cm at the back, 5
cm on one side, and the other side must be opened more than 40
cm.
b. If one side of the oven is placed flush to a wall, the other side or top
must not be blocked.
5cm
Counter-top
En-2

Installation and Connection

15cm
10cm
Open
4. Do not place this oven near an electric or gas cooker range.
5. The feet should not be removed.
6. This oven is only for household usage. Do not use outdoors.
7. Avoid using the microwave oven in high humidity.
8. The power cord should not touch the outside of the oven. Keep
the cord away from hot surfaces. Do not let the cord hang over
the edge of a table or work top. Do not immerse the cord, plug
or oven in water.
9. Do not block the air vents on the top and back of the oven. If these
openings are blocked during operation the oven may overheat. In
this case the oven is protected by a thermal safety device and
resumes operation only after cooling down.
10. This appliance is not intended to be operated by means of an
external timer or separate remote control system.
WARNING
1. The door seals and door seal areas should be cleaned with a damp
cloth. The appliance should be inspected for damage to the door
seals and door seal areas and if these areas are damaged the
appliance should not be operated until it has been repaired by a
service technician trained by the manufacturer.
2. Do not attempt to tamper with or make any adjustments or repairs
to the door, control panel housing, safety interlock switches or any
other part of the oven. Do not remove the outer panel from the oven
which gives protection against exposure to microwave energy.
Repairs should only be done by a qualified service person.
3. Do not operate this appliance if it has a damaged CORD OR PLUG,
if it is not working properly, or if it has been damaged or dropped. It
is dangerous for anyone other than a service technician trained by
the manufacturer to perform repair service.
4. If the supply cord of this appliance is damaged, it must be replaced
with the special cord available from the manufacturer.
5. Only allow children to use the oven without supervision when
adequate instructions have been given so that the child is able to
use the oven in a safe way and understands the hazards of improper
use.
6. Liquids and other foods must not be heated in sealed containers
since they are liable to explode.