Lengthening The Cutting Lines; Best Cutting Practice - Grizzly ERT 450/8 Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
ƒ
Pull down the lever (6) and turn the
handle rod (1) until it snaps into the
desired position.
Adjusting the spacing bow
(flower protection):
The spacing bow keeps plants and stalks
that are not to be cut away from the cut-
ting lines.
Flap down the spacer bow (13) for
trimming.
If the spacing bow is no longer re-
quired, it can be pushed away back-
wards (park position).

Lengthening the cutting lines

A short or worn string will make
bad cuts. If you notice reduced cut-
ting performance, you should the-
refore check if there is still enough
string on the spool. Pull the power
plug first! Spool replacement is
detailed in section „Replacing the
Trimming Assembly".
Fully automatic dual line system
The equipment features a fully automatic
dual line system.
The lines will automatically elongate every
time you turn on the appliance. To support
proper line elongation, ensure that the coil
has stopped moving completely before
turning on the appliance again.
If the lines should be longer that defined
by the cutting circle then they will be au-
tomatically cut to the correct length by the
line cutter
Regularly check the nylon lines for
damage and whether the lines still
have the correct length defined by
the line cutter
When no line ends are visible:
Renew the line spool (see "Cleaning
and maintenance").
Adjusting the line length manually:
Disconnect the plug from the mains
socket!
Press the retaining head (
lease it again and pull the ends of the
cord out.

Best cutting practice

WARNING. Danger of injury!
- Before starting the trimmer check
that the cutting head will not
come into contact with stones,
rubble or other foreign bodies.
- Switch on the trimmer before you
approach the grass that is to be cut
- Do not cut moist or wet grass.
- Do not overload the trimmer duri-
ng operation.
- Avoid contacting solid obstacles
(stones, walls, fences, etc.) since
this would make the string wear
out too quickly. Use the edge of the
protective cover to keep the appli-
ance away from such obstacles.
- Always trail the extension cable
behind you. Do not pass the ope-
rating trimmer over the extension
cable as the cable could be da-
maged.
UK
17) re-
Cut the grass
by swaying the
trimmer side-
ways to the right
and left.
Cut slowly,
tipping the appli-
ance fowards by
about 30°.
111

Publicité

Table des Matières
loading

Table des Matières