Whirlpool SF114PXSB0 Guide D'utilisation Et D'entretien page 13

Surface burners will not operate
Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.
Is the control knob set correctly?
Push in knob before turning to a setting.
Are the burner ports clogged?
On sealed burner models, see "Sealed Surface Burners"
section.
On open burner models, see "Surface Burners" section.
Surface burner flames are uneven, yellow and/or noisy
Are the burner ports clogged?
On sealed burner models, see "Sealed Surface Burners"
section.
On open burner models, see "Surface Burners" section.
On models with caps, are the burner caps positioned
properly?
See "Sealed Surface Burners" section.
Is the air/gas mixture correct?
Contact a designated service technician to check the air/gas
mixture, or see the Installation Instructions.
Is propane gas being used?
The appliance may have been converted improperly.
Contact a trained repair specialist.
Surface burner makes popping noises
Is the burner wet?
Let it dry.
Cookware not level on cooktop
Is the range level?
Level the range. See the Installation Instructions.
Is the proper cookware being used?
Use cookware with a flat bottom. See "Cookware" section.
Excessive heat around cookware on cooktop
Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ¹⁄₂" (1.3 cm) outside the cooking area.
Are the right side surface burners rotated toward each
other?
See "Burner Rotation" section.
Oven will not operate
Is the power outlet properly wired and polarized?
Try another outlet to check for proper wiring and polarity.
Is this the first time the oven has been used?
Turn any one of the surface burner knobs on to release air
from the gas lines.
Is the electronic oven control set correctly?
See "Electronic Oven Control" section.
On some models, is the Oven Lockout set?
See "Oven Lockout" section.
Is the main or regulator gas shutoff in the off position?
Contact a designated service technician or see the
Installation Instructions.
Oven makes muffled ticking noise when in use
This is normal and occurs when the oven burner cycles on
and off to hold the set oven temperature.
Oven burner flames are uneven, yellow, or noisy
Is propane gas being used?
The appliance may have been converted improperly. Contact
a trained repair specialist.
Is the air/gas mixture correct?
Contact a designated service technician to check the air/gas
mixture or see the Installation Instructions.
Oven temperature too high or too low
Does the oven temperature calibration need adjustment?
See "Oven Temperature Control" section.
Display shows messages
Is the display showing a flashing time?
There has been a power failure. Press OFF/CANCEL to clear
the display. Reset the clock, if needed. See "Clock" section.
Is the display showing "F" followed by a number?
Press OFF/CANCEL to clear the display. If an "F" code
appears again, contact a trained repair specialist.
Cooktop cooking results not what expected
Is the proper cookware being used?
See "Cookware" section.
Is the control knob set to the proper heat level?
See "Cooktop Controls" section.
Baking results not what expected
Was the oven preheated?
Wait for oven to preheat before placing food in oven.
Are the racks positioned properly?
See "Positioning Racks and Bakeware" section.
Is there proper air circulation around bakeware?
See "Positioning Racks and Bakeware" section.
Is the batter evenly distributed in the pan?
Make sure batter is level in the pan.
Is the appliance level?
Level the appliance. See the Installation Instructions.
Are baked items too brown on the bottom?
Decrease oven temperature 10°F to 30°F (5°C to 15°C).
Are crust edges browning early?
Use aluminum foil to cover the edge of the crust and/or
reduce baking temperature.
13