Section Six: CARE AND MAINTENANCE
To Set Self-Clean for the Large Main Self-Cleaning Oven
1. Select CLEAN using the Selector switch.
2. Set Oven Control Knob to CLEAN.
▲ Cooling Blower turns on.
▲ OVEN indicator light and HEATING light turn on.
▲ Lock light turns on.
▲ Temperature indicator rotates to CLEAN after five minutes.
▲ The door closing process takes approximately 60 seconds
to complete, at which time the door becomes locked.
Check to make certain the door is locked.
At the End of the Clean Cycle
The Clean cycle takes 4 to 5 hours to complete. The blower and the
OVEN indicator light and the CLEAN light turn off when the cycle is
finished. Do not turn the selector switch or the oven control knob to the
OFF position until the LOCK light goes off.
1. Select OFF using the Selector Switch.
▲ The door latch will open automatically when the oven is
°
below 500
F and the automatic Door Lock completes its 60
second cycle to the OPEN position.
▲ The cooling blower turns off when the oven temperature
drops to 325
2. Turn Oven Control Knob to OFF position.
Cleaning Hints
1. The porcelain enamel finish is acid resistant, but not acid proof.
Acidic foods, such as citrus juices, tomatoes, rhubarb, vinegar,
alcohol or milk, should be wiped up and not allowed to bake onto the
porcelain during the next use.
2. Remove the oven racks. See Racks, on Range Cleaning
Recommendations, Page 38.
3. The heating elements in the oven do not require cleaning; the
elements burn themselves clean when the oven is in use. Both
elements are permanently connected. It is not necessary to clean
the broiler shield above the broil element.
4. The secondary oven (48" models only) does not have have the Self-
Clean feature. Use caution when cleaning the secondary oven. Use
hot sudsy water; rinse and dry thoroughly.
Self-Cleaning the Oven
°
.
30" Model
OVEN CONTROL KNOBS
32
CAUTION
The interior of the oven will
still be at baking tempera-
tures when the LOCK light
turns off and the oven door
can be opened.