Section 6: Care And Maintenance; Self-Cleaning The Oven - Thermador Professional PRO-GRAND PD30 Manuel D'utilisation Et D'entretien

Section Six: CARE AND MAINTENANCE
LARGE MAIN OVEN
The self-cleaning mode of your new range features
pyrolytic self-cleaning. When set to the CLEAN
mode, the oven reaches a high temperature,
°
approximately 830 F, that burns off the food soil.
When the oven is set for CLEAN, the cooktop burners
and electric griddle may be used. The secondary
oven (48" Models), and the grill cannot be used.
It is common to see smoke and/or flames during
the clean cycle, depending on the content and
amount of soil remaining in the oven. If a flame
persists, turn off the oven and allow it to cool before
opening the door to wipe up the excessive food soil.
At the end of the CLEAN cycle, some gray ash or
burned residue may remain inside the oven. This is
a mineral deposit that does not burn or melt. The
amount of ash depends on how heavily soiled the
oven was before it was cleaned. It is easily removed,
when the oven is cold, using a damp paper towel,
sponge, or cloth.
Wipe off any smoke residue that remains on the front
frame with Formula 409
remains, use a mild liquid cleanser. The amount of
smoke stain is directly related to the amount of food
soil left in the oven at the time of self-cleaning. Clean
the oven often.
BEFORE SELF CLEANING THE OVEN
Wipe out puddles of grease and any loose soil that can
be easily removed.
Remove any soil that is outside the door seal area.
This appliance is designed to clean the oven interior
and that portion of the door that is inside the oven. The
outer edges of the door and the oven cavity are not in
the cleaning zone. Wipe this area clean BEFORE
SETTING THE OVEN TO SELF-CLEAN.
• Remove all utensils.
• Remove Racks.
• Clean the oven front frame and outer door
edges. Wipe up large spillovers and
grease.

Self-Cleaning the Oven

® ®
or Fantastik . If stain
• Be sure the light bulbs and glass covers
are in place.
• Turn on the ventilator hood above the
range and leave it on until the oven has
completed the self-clean cycle.
IMPORTANT: For the first
Self-Cleaning cycle, remove
small animals and birds from
the kitchen and surrounding
areas. Open
window
ventilation.
If another clean cycle is initiated at the end of a clean
cycle and the temperature of the oven is still above
°
500 , the LED will start blinking to indicate the range
has not completely cooled down after the first cycle.
The oven cannot be used until the oven temperature
°
drops below 500 and the door is unlocked.
LOCK
When the CLEAN cycle starts, the LOCK light turns
on, and the automatic door lock cycle begins. The
temperature gauge begins to move to CLEAN five
minutes after the clean mode is initiated. Check the
door when the LOCK light comes on to confirm that
it is locked. You can stop the clean cycle by selecting
the OFF position. The lock light will turn off only after
the oven has cooled below 500
door lock has completed its cycle to the open position.
Make certain that the oven door is locked at the
beginning of the self-cleaning cycle.
31
a nearby
for additional
°
F, and the automatic