Preliminary instructions.
Before using MIO-CARE clean the skin of the area to be treated; with the cable disconnected
from MIO-CARE, connect the electrostimulation cable jacks to the self-adhesive electrodes;
position the self-adhesive electrodes on the skin (see photos of electrode positions); connect
the impulse transmission cables to the relative jacks (Channel 1 and/or Channel 2), then turn
Mio-Care on.
Splitting leads use: please use splitting leads if you want to double electrodes number for
each channel. Connect the splitting cable jacks to the self-adhesive electrodes, with the cable
disconnected from MIO-CARE; position the self-adhesive electrodes on the skin (see photos of
electrode positions); connect the splitting leads cables to the impulse transmission cables that
are connected to the relative jacks (Channel 1 and/or Channel 2), then turn Mio-Care on.
Warning: make sure that MIO-CARE is switched off before disconnecting the electrodes at the
end of the treatment.
Operating instructions (N.B. read the whole manual before using the
equipment)
1.
Turn MIO-CARE on using the ON/OFF button.
2.
The display shows the number of the programs on the upper side, the selected program
number on the middle left side and on the right the program time:
IACER S r
1. PRG group selection
2. Selected program
3. CH1 intensity
4. Active channel
5. Low battery status
6. Next phase
7. CH2 intensity
8. Countdown timer
9. Device running
45
PG95 Rev 02 Ed 31 01 12