Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
7. Maintenance Instructions
When correctly installed and used for its intended purpose, the Guard Locking Device is maintenance-free.
We recommend performing a visual inspection and a function test at regular intervals including the following
steps:
• Safety function test.
• Check Guard Locking Device and actuator for secure seating.
• Check maximum lateral offset of the actuator unit and the Guard Locking Device.
• Check maximum angular offset (see "Installation Instructions").
• The cable gland and the terminals must be fully intact.
• Check the switch housing for damage.
• Remove any contamination.
Damaged or defective devices must be replaced.
• Adequate measures must be taken to ensure protection against tampering either to prevent tampering
of the safety guard, for instance by means of replacement actuators.
Maintenance Instructions
40
Publicité
Chapitres
Table des Matières
