Parts Counting; Determination Of The Reference Weight By Weighing - KERN and SOHN CXB Série Mode D'emploi

8 Parts counting

With parts counting you can either count parts into a container or remove parts from
a container. To count a greater number of parts the average weight per part has to
be determined with a small quantity (reference quantity). The larger the reference
quantity, the higher the counting exactness. High reference must be selected for
small parts or parts with considerably different sizes.

8.1 Determination of the reference weight by weighing

Set balance to zero and tare, as required.

a
PRE-
TARE
Place a known number of parts on the balance as reference weight
118. 3 ��
a
PRE-
TARE
If the "Weight" display is stable, enter the number of parts via number keys.
The input is shown in the unit-weight window.
118. 3 ��
a
PRE-
TARE
Weight
While the "Number of pieces" display is flashing (3 sec) confirm by
118. 3 ��
a
PRE-
TARE
Dead stop control is carried out and the calculated reference weight appears on the
display.
118. 3 ��
a
PRE-
TARE
Weight
Now you can place the parts to be counted onto the weighing plate. All quantity
parameters of your goods to be weighed are displayed:
26
0�
Piece weight
SAnnP� ------��
118. 3 ��
a
PRE-
TARE
Reference weight
0�
M+
0�
M+
100�
M+
M+
M+

0��
0��
1��
Quantity
button.
100��
Quantity
CXB-BA-e-1622