Hendi 209905 Mode D'emploi page 8

How to use
Make sure the tap is closed
Fill the appliance with wine up to the MAX level indicated on the inner wall of the
reservoir.
Fasten the lid securely by turning it until it locks into place.
Switch the appliance on by setting the dial to position 1.
Use the thermostat knob to select the desired temperature. (Maximum
temperature setting is 100
selected temperature
When the wine has reached the selected temperature, the green light will be
illuminated.
After use / Empty the urn
Switch the appliance off by pulling the plug out of the wall socket.
Place a drip tray under the tap.
Open the tap and drain the wine out of the urn.
When the urn has been emptied, close the tap.
Maintenance tips
Always pull the plug from the wall socket before cleaning the urn.
If the urn is subjected to heavy use, you will need to de-scale it at regular
intervals.
Never immerse the urn in water or other liquid cleaning products.
Clean the urn with a damp cloth.
Never use abrasive or caustic cleaning products.
Always ensure the electrical connections remain absolutely dry.
When you drain off dirty water, leave the tap open and rinse the urn with clean
water.
Defects
Defect
Urn does not
work at all.
Urn switches off
automatically.
Urn does not
reach the
selected
temperature.
When in doubt always contact your supplier!
.
°
C.) The actual temperature can differ from the
Problem
Neither red light nor
indicator light is
illuminated.
The red light is not
illuminated.
Green light is not
illuminated.
Cause
No mains voltage.
Urn has
exceeded
maximum safety
limits.
Thermostat does
not work.
Heating element
does not work.
Possible solution
Check the electrical
connections.
Once it has cooled off,
the urn will switch on
again automatically.
Contact your supplier.