Receive Mode; Measurements; Connections; Receive/Measure - Chauvin Arnoux C.A 61 Mode D'emploi

3.2/ RECEIVE MODE

Prior to any measurement, it is preferable, even necessary, to configure your instru-
ment depending on the type of application (chapter 3.1 Configuration).

3.2.1 Measurements

Connections

Instrument switched off, connect the input (sensor, controller, etc.) to the IN and COM
terminals of model C.A 61, or the IN terminals of models C.A 63 and C.A 65. Take care to
respect the polarity marked on the case of your instrument.
C.A 61
IN COM
+ -
u ¬
i
¬

Receive/measure

instrument connected
switched off
ON
Display test for 3
seconds approx.
then measurement
display (IN symbol)
V mA %
measurement display
in the chosen unit
OUT
IN
G +
}
C.A 61
C.A 63
OUT
- -
+
analogue
output
With your instrument correctly configured and
connected, make the measurements by pressing
the button.
ON
To change from receive mode (IN symbol)
to emission mode (OUT symbol), and vice-versa,
press the
IN OUT
37
C.A 65
IN
-
+
analogue
button.
OUT
-
+
output