Maintenance - RIDGID R860445 Manuel D'utilisation

OPERATION
 Install the battery pack.
 Grasp the high pressure hose by the spring guard and
remove it from the hose clips.
 Point the grease coupler towards an approved grease
container.

MAINTENANCE

WARNING:
When servicing, use only identical replacement
parts. Use of any other parts can create a hazard
or cause product damage.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which can
result in serious personal injury.
NOTE: ILLUSTRATIONS START ON PAGE 11
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
This product has a 90-Day Satisfaction Guarantee Policy,
as well as a Three-year Limited Warranty. For Warranty and Policy details,
please go to powertools.ridgid.com or call (toll free) 1-866-539-1710.
 Slide lock on/off button to the lock on position, and press
the switch trigger to start the flow of grease.
 If the grease gun continues to stall and grease does not
flow, repeat these steps.
CLEANING THE CHECK VALVE AREA
See Figure 14, page 13.
If grease does not flow freely when the switch trigger is
depressed, contaminants may be clogging the check valve
area.
To clean the check valve area:
 Lock the switch trigger in the "off" position and remove
the battery pack.
 Remove the check valve bolt, washer, spring, and ball
from the check valve area.
 Use a clean dry cloth to remove grease and contaminants
from the bolt, washer, spring, ball, and check valve area.
 Reinstall the ball, spring, washer, and check valve bolt.
Tighten the bolt to secure.
STORING THE GREASE GUN
 Lock the switch trigger by sliding the lock on/off button
into the locked position and remove the battery pack.
 Remove the grease tube.
 Discard grease cartridge (if applicable) and remove any
old grease from inside the tube.
 Reinstall the grease tube.
 Install battery pack, point the grease coupler towards an
approved grease container, and run the tool until all the
grease is expelled.
 Lock the switch trigger in the "off" position and remove
the battery pack.
 Unlock the switch trigger.
 Store the unit, accessories, and grease in an area that
does not reach freezing temperatures. Do not store near
furnace or other sources of heat that could dry out the
pump, high pressure hose, or other components. Keep
out of the reach of children.
10 - English