AVG AVW-308CS Instructions D'installation Et Guide De L'usager page 23

3. OPERATING THE HOOD (continued)
Controls (continued):
• Adjusting the blower (motor) speed:
•
Press Power button once to turn on the system. The Blower Power Indicator icon
flashes, showing that the blower is ready. Decrease (-) button will decrease the
speed of the blower from 6 to 1 (strongest to quietest). Increase (+) button will
increase the speed of the blower from 1 to 6 (quietest to strongest).
•
Press Power button once to turn off the system
• Adjusting the timer function:
•
While the blower is not running, press and hold Decrease (-) button over 3 seconds
to enter timer mode. Adjust to desired time by pressing the Increase (+) or the
Decrease (-) button (for minimum of 1 minute to a maximum of 15 minutes). This
setting will be saved immediately.
• Activating the timer function:
•
While the blower is running, press and hold the Power button for over 3 seconds to
activate Power-off Delay Digital Timer. The Power-off Delay indicator will light up
and Power-off Delay Digital Timer will begin to countdown; when it reaches zero,
the blower will shut down.
• Adjusting the light:
•
Press Light button once to turn lights on and once again to turn lights off.
•
While the lights are off, press and hold Light button for over 3 seconds to adjust the
intensity of the lights. The level of brightness will be stored in system's memory.
CAUTION: DO NOT touch the lights until they are switched OFF and cooled.
Note:
Light settings are independent from other settings (including power-off delay) and
lights have to be manually turned on or off.
Note:
The system saves user configurations. Settings such as light, timer and blower speed
will remain the same the next time it is turned on.
.
23