Using Your Steam Pocket Mop; Lift-Away ® Pro; Important - shark S3973 Série Guide D'utilisation

Using Your Steam Pocket
IMPORTANT: Make sure you do not use the Shark
Grip pad and adding water to the water tank first. When you are using the Steam Mop for the first time, it
™
might take longer than the normal 30 seconds to start steaming.
IMPORTANT: Do not use on unsealed wood or unglazed ceramic floors. On surfaces that have been treated with
wax and on some no-wax floors, the sheen may be removed by the heat and steam action. Test an isolated area
of the surface to be cleaned before proceeding. Check the use and care instructions from the floor manufacturer.
fig. 9
NOTE: To prolong the life of your Steam Mop, we
recommend using distilled water.
NOTE: Sweep or vacuum your floors prior to
cleaning with your Steam Mop.
1
Twist the upper cord holder to unwrap the power cord
completely (fig. 9). Plug into an electrical outlet.
2
When it's first plugged in, the unit will be in Standby
mode. The 3 lights below the Steam Control Button
will blink to indicate Standby mode.
3
To select the steam mode, press the Steam Control
Button once for DUST (1 blue light) twice for MOP (2
blue lights) or three times for SCRUB (3 blue lights).
Pressing a fourth time will place the unit on Standby.
4
Clean your floors with a forward and backward motion.
5
When you need an extra burst of steam to clean
a stuck-on stain, you can use the Steam Blaster
feature. Flip the head over so that it is behind the
mop body, then tilt the mop handle down. This will
cause the the Steam Blaster (fig. 10) to emit a
concentrated blast of steam onto the stain.
CAUTION: While in Steam Blaster mode, do not
leave stationary for more than one minute.
CAUTION: Do not scrub any one area for an
extended period of time.
Mop
®
Lift-Away
®
fig. 10
6
7
8
9
10
™
Pro Steam Pocket Mop without attaching a Dirt
® ®
fig. 11b
To stop the Steam Blaster spray, simply raise the
handle. You can then flip the mop head back into its
original position and continue cleaning.
When you are done mopping, press the Steam Control
Button until you return to Standby mode.
To remove the Dirt Grip pad, simply lift the mop
straight up by the handle until the Intelli-Mop
hanging straight down. Press down on the pad release
buttons on the neck of the mop head (fig 11a), and
both sides of the head will drop open, releasing the
pad (fig 11b).
Once the Dirt Grip pad has been released, close the
Intelli-Mop Head. To close, gently press one side of
the Intelli-Mop Head to the floor until that side clicks
into place. Repeat on the other side.
When the water tank is empty, the Steam Mop will
stop producing steam. You can refill the water tank
at any time as long as the Steam Mop is unplugged.
Follow the water tank filling instructions on page 7.
NOTE: Please wait 2 to 3 minutes for the Steam Mop
to cool off before switching the mop head. Never
leave the Steam Mop with a damp or wet Dirt Grip
pad on any floor for an extended period of time.
fig. 11a
Head is
™
sharkclean.com 8