Caring For Your Steam Pocket Mop; After Use And Storage - shark S3973 Série Guide D'utilisation

Caring for Your Steam Mop
fig. 21

AFTER USE AND STORAGE

1
Press the Steam Control Button until it starts to blink,
indicating that you are in Standby mode. Unplug the
cord from the outlet and place the Steam Mop into
the upright position. Let it cool.
2
To remove the Dirt Grip
up by the handle until the Intelli-Mop
straight down. Press the pad release buttons on the
neck of the mop head, and both sides of the Intelli-Mop
Head will drop open, releasing the pad. Once the pad
has been released, close the Intelli-Mop Head.
3
If the Intelli-Mop Head is not attached to the mop, the
pad can still be removed. Press down on the release
button on the Intelli-Mop Head post to release the pad
(fig. 21).
4
Empty the water tank before storing. To empty the
tank, hold the Steam Mop beside a sink. Open the
water tank lid, then lean the unit over the sink. Let
the water drain out, then close the lid.
5
To store the Steam Mop, wait until after it has cooled
and the steam has been released. Then remove the
Intelli-Mop Head and hang the mop by its handle on a
large hook (not included) (fig. 22).
fig. 22
pad, lift the Steam Mop straight
™
Head is hanging
™
fig. 23
fig. 24
DIRT GRIP PAD CARE INSTRUCTIONS
™
Care
Machine-wash the Dirt Grip pads separately with warm
water using liquid detergent.
NEVER USE BLEACH, POWDERED DETERGENT, OR
FABRIC SOFTENERS as they may damage or leave
a coating on the Dirt Grip pads that will reduce their
cleaning performance and absorbency. Dirt Grip pads
should be line-dried or tumble-dried on a low setting, as
this will extend the life of the microfiber fabric (fig. 23).
Loose fibers can indicate wearing of the microfiber
fabric. Do not pull the loose fibers, as this can cause the
weave to come undone. Simply trim the loose fibers with
scissors (fig. 24).
Replacement Dirt Grip pads
For best cleaning results, we recommend replacing your
Dirt Grip pads every 3 to 4 months following normal use.
As with any fabric, dirt particles, grease, friction, and
repeated washing can cause the fibers to break down, and
you may notice an increase in the effort needed to push or
pull the mop.
You can purchase replacement Dirt Grip pads and
other accessories by visiting sharkclean.com or calling
1-800-798-7398.
STEAM NOZZLE CARE
If you believe the main steam nozzle or the Steam Blaster
nozzle is clogged, please contact Customer Service at
1-800-798-7398 or consumer-services@sharkninja.com
™
sharkclean.com 14