Charging Your Cordless Floor & Carpet Sweeper; Using Your Cordless Floor & Carpet Sweeper - shark V2940C Manuel Du Propriétaire

CHARGING YOUR CORDLESS FLOOR AND CARPET SWEEPER
1 Always make sure that the unit
is turned off. (Fig. 3)
2 Insert the charger plug into the
hole on the back of the unit.
Plug the charger into a wall
outlet. The light next to the
power button will illuminate
when the unit is charging. If the
unit is plugged in and the light is
not illuminated, press the power
button once. The light should
now be illuminated indicating
that the unit is charging.
(Fig. 4)
USING YOUR CORDLESS FLOOR AND CARPET SWEEPER
Fig. 5
1 Press the power button to start
the unit. The lights on the unit
will illuminate. When finished
cleaning, press the power
button again to turn the unit off.
(Fig. 5)
2 You can adjust the speed of
the brush roll to suit the floors
that you are cleaning. Press the
OFF
Fig. 3
3 Charge the battery for 20 hours
before initial use and 16 hours
for each recharge. Your cordless
floor and carpet sweeper is
powered by Ni-Cd batteries that
need this time to build up their
charge.
4 Remove the charging adapter
from the unit after the charging
period has completed. Storing
the unit with the adapter
attached and plugged in will
reduce the battery life.
FLOOR CARPET
Fig. 6
button on the right (opposite
the power button) to switch
between speeds. One light
indicates the speed optimized to
clean bare floors and two lights
indicate the speed optimized to
clean carpets and larger debris
on bare floors. (Fig. 6)
3 Do not use the unit to pick up
Fig. 4
IMPORTANT: Although many
adaptors look similar, it's
important to use only the
adaptor that came with the unit
(XA2940).
NOTE: If you notice a decrease in
run time over time, recondition
the batteries by running the
sweeper until the sound drops
significantly, then turn off the
unit and charge for 20 hours.
This battery reconditioning process
can also be performed as monthly
maintenance.
If the brush roll stops moving, it's probably
due to the anti-jam feature. This feature
protects the motor from becoming overheated.
If the brush becomes overloaded, it will stop
turning and both speed indicator lights will
stay on. Turn off your unit by pressing the
power button once. See page 9 for instructions
on removing or cleaning the brush roll. Wait
for 10 seconds to let your unit cool down. Now
press the power button again and you're ready
to resume cleaning!
liquids or clean wet floors.
4 Do not use the unit on concrete,
tar or other rough surfaces.
5 Do not use the unit to pick
up pieces of string or fabrics.
Do not use the unit to clean
tasseled or frayed carpets.
www.sharkclean.com
English
7