Error Displays/Messages - Sony MDX-F5800 Mode D'emploi

Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna control lead (blue)
or accessory power supply lead (red) to the
power supply lead of a car's antenna booster.
(Only when your car has built-in FM/AM
antenna in the rear/side glass.)
• Check the connection of the car antenna.
• The auto antenna will not go up.
t Check the connection of the power
antenna control lead.
• Check the frequency.
• When the DSO mode is on, the sound is
sometimes hampered by noises.
t Set the DSO mode to "OFF" (page 21).
Automatic tuning is not possible.
• The local seek mode is set to "ON."
t Set the local seek mode to "OFF"
(page 14).
• The broadcast signal is too weak.
t Perform manual tuning.
The "STEREO" indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set the monaural reception mode to
"ON" (page 15).
A program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
t Cancel monaural reception mode
(page 15).
26

Error displays/Messages

Error displays
(For this unit and optional MD/CD changers)
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
BLANK* 1
No tracks have been recorded on an MD.*
t Play an MD with recorded tracks on it.
ERROR* 1
• An MD is dirty or inserted upside down.*
t Clean or insert the MD correctly.
• A MD/CD cannot play because of some
problem.
t Insert another MD/CD.
FAILURE (Illuminates until any button is
pressed.)
The connection of speakers/amplifiers is
incorrect.
t See the installation guide manual of this
model to check the connection.
FAILURE (Illuminates for about 1 second.)
When the XM tuner is connected, storing an
XM radio channel into a preset failed.
t Be sure to receive the channel that you
want to store, then try it again.
HI TEMP
The ambient temperature is more than 50°C
(122°F).
t Wait until the temperature goes down
below 50°C (122°F).
NO DISC
No disc is inserted in the MD/CD unit.
t Insert discs in the MD/CD unit.
NO MAG
The disc magazine is not inserted in the CD
unit.
t Insert the magazine in the CD unit.
2
2