Safety Hazards; Improper Use - Wetrok Sprinter XR70 Mode D'emploi

Operating instructions
GB/RSA
We are pleased that you have chosen to
purchase one of our products. Before
putting the machine into operation, please
take the time to read through these
operating instructions.
About this document
These operating instructions will provide
you with all the information you need for the
proper and safe use and maintenance of
the Wetrok Sprinter XR 70/90 and Wetrok
Sprinter XR 70/90 TwinTurbo. These
instructions should be kept where they will
be readily accessible to those who operate
the machine.
The fold-out page contains photographs
that are referred to in the description of the
machine.
Proper use
This machine is constructed for the
commercial cleaning of hard floor coverings
in indoor areas in accordance with the
operating instructions contained herein.
Any other use, in particular
- as a tractor or means of transport
- for removing dusts that are hazardous to
health
- for vacuuming agents that are mildly
combustible, toxic, caustic, irritating, or
injurious to health
- for cleaning textile floor coverings
is improper and, because of the
associated risks, prohibited.
CAUTION!
- This unit is not suitable for the collection
of hazardous dusts.
- This unit is intended for use in a dry
environment only; it must not be used or
stored out of doors in wet conditions.
- Not for use on surfaces with a gradient /
incline that exceeds the maximum
gradient / incline marked on the unit.
- Use caution when turning on a gradient /
incline. Drive slowly and carefully. If the
gradient is greater than 2%, you must
drive only perpendicularly to the gradient.
Turning is not permitted.
- The machine must under no
circumstances be made to move at a
speed greater than 8.5 km/h.
Attention! Use only brushes or pads that
are recommended by Wetrok or specified
in the operating instructions. Use of other
brushes or pads may compromise safety.
Machine description
I. Machine details
A1 Driving wheels
A2 Brush housing
A3 Diversion roller
A4 Drive wheel / drive motor
A5 Accelerator pedal
A6 Brake pedal
30 / 74
B1 Adjusting screw for nozzle lead angle
B2 Suction nozzle with replaceable
suction lips
B3 Nozzle height adjusting screw with
suction nozzle support wheel
B4 Nozzle mounting screws
C1 Drive wheel / drive motor
C2 Parking brake release lever
D1 Drain cock for recovery tank
D2 Battery cover (removable)
D3 Drain cock for fresh water tank
E1 Tank housing
E2 Batteries
F1 Foam sensor
F2 Diaphragm tank / dirty water
F3 Coarse debris filter basket
F4 Dirty water intake
F5 Diaphragm tank / fresh water
G1/H1 Emergency stop connector
G2 Main key switch
H2 Battery charge connector
II. Fuses: 5 AT (5 Amps, slow blow) for
Linak nozzle, horn and permanent feed
2. General safety instructions / For your
safety
This machine has been constructed
according to the current state of the art and
accepted safety rules. It has been
inspected electronically and complies with
European safety standards. It makes use of
various circuit breakers that serve as
protective devices.
Nevertheless, risks may arise, primarily as
the result of improper use or non-
observance of the rules and instructions
contained in this manual.

2.1 Safety hazards

Electrical voltage / electrical current
Warning!
The cable connection between batteries
and machine (G1) must be removed before
any work is performed on electrical
components. Contact with voltage or
current incurs the risk of an electrical shock
that may result in severe injury or even
death.
Before any work is performed on electrical
components, the machine must always be
turned off and isolated from battery voltage
by pulling the emergency stop connector
(G1).
Moving machine and moving parts
Warning!
- The moving machine and rotating
brushes pose the risk of injury.
- Keep hands and feet away from the
brushes.
- Avoid contact with clothing or hair.
Other hazards
Warning! The formation of a short circuit
across the terminals of a battery by a hand
or conductive object poses the risk of injury
or burns.

2.2 Improper use

Any use of the machine other than for the
purpose described under "Proper use" or as
contractually agreed is prohibited.
Operation of the machine in a technically
imperfect condition or in disregard of the
following rules is prohibited:
- Safety features must not be dismantled or
bypassed.
- Rebuilding or making alterations to the
product is prohibited.
- Damage caused by improper handling or
misuse in disregard of these instructions
will void the warranty. Wetrok accepts no
liability for consequential damage or loss.
2.3 Emergency switch-off / Emergency
stop
This machine is equipped with:
- An electromagnetic parking brake,
activated when the current is off.
- An emergency stop connector near the
driver's seat for interrupting the power
supply in an emergency or during
servicing (see Fig. G and H).
- Pause function when vehicle driver is not
present. This prevents the machine from
accidentally travelling without a driver.
Mechanical belt brake with foot pedal
-
(A6).
2.4 Organizational matters
It is the responsibility of the operator to
ensure that
- the machine is used only by persons who
have been instructed in its operation and
are expressly authorized for its use
- accepted work safety rules are complied
with
- any further state or internal company
regulations are observed
- all operators are familiar with the safety
rules and have received product-specific
training in the use of the machine
- all operators have read and understood
the operating instructions before using the
machine
- responsibilities for the operation,
maintenance and repair of the machine
are clearly defined and adhered to
- malfunctions and damage are reported
immediately to the service facility
2.5 Emergencies / In an emergency:
- Administer first aid immediately.
When incidents occur, do not put machine
back into operation before it has been
inspected by Wetrok or by technical staff
authorized by Wetrok.