Trevi XF 3200 PRO Mode D'emploi Et Branchement page 15

ENGLISH
TROUBLESHOOTING
If a problem occurs, follow the steps in the table below.
If the problem still can't be solved, please contact your retailer.
Problem
No sound when power is
turned ON
Distorted sound
No sound from the mi-
crophone
No sound comes after
inserting USB/SD Card
Battery status indicator on
the display flashes when
the charge is low
Unable to charge or the
battery works only for short
duration
If Speaker makes loud
noises
INFORMATION NOTE ON THE REMOVAL BATTERY
Warning: Only high-qualified personnel should perform this operation!
BATTERY REMOVAL
The appliance should not be plugged to the mains socket when performing this operation!
1. Remove the screws that secure the slot panel battery;
2. Remove the metal panel;
3. Remove the screws that secure the supports of the battery, remove the supports, disconnect the battery and remove it.
INFORMATION ON DISPOSAL BATTERY
Used batteries should not be disposed of with household waste or thrown into fire or water. Used batteries should be recycled or
disposed of in separate waste collection centres.
Possible cause
1. No input sound source comes
2. Volume knob in the lowest position
3. Voice switch off
4. USB/SD card not plugged
1. Volume is too loud
2. Audio file error
1. Microphone socket may not be plugged
properly.
2. Microphone switch may not be on.
3. Microphone volume is on lowest mode.
1. Incorrect file format
2. USB/SD may not be plugged properly
The charging power cable is not inserted
correctly
1. Connect with power cord to charge
2. Battery not fully charged
3. Battery life may have ended
1. Microphone switched on but may too
close to the speaker
2. Microphone switched on but is not being
used
3. Microphone volume may be too loud
4. Mobile phone is being used too close to
the speaker
5. Other wireless equipment may be placed
very close to the speaker
1. Input AUX signal
2. Adjust volume
3. Turn on voice switch
4. Plug USB/SD card,play MP3
1. Turn the volume down
2. Check and change the audio file
1. Ensure the microphone is correctly plugged
into the socket.
2. Turn on the microphone
3. Adjust the microphone volume as per users
wish
1. File format should be MP3
2. Plug USB/SD card correctly
Connect the power cord firmly and check that
the back charging light is on
1. Check if power cord connected properly
2. Extend charging time;normally it takes 6-8
hour to fully charge
3. Replace old batteries with the same specifica-
tion as the old batteries.
1. Keep the microphone 2 meters away from
the speaker
2. Turn off microphone if not in use.
3. Adjust microphone volume to lower mode
4. Keep mobile away from the speaker whilst a
ending a call.
5. Keep the speaker away from other wireless
equipment
15
XF 3200 PRO
Solution