End Of Use; Troubleshooting - Imetec INTELLIVAPOR ECO Mode D'emploi

EN
Switch the appliance off by pressing the ON/OFF button (6);
• Disconnect the plug (7) from the socket;
• wait for the appliance to cool down completely before putting it away. The reservoir (1)
does not have to be emptied.
NOTES:
If the appliance is not to be used for several weeks, remove and empty the water
reservoir (1) completely.
This chapter describes the most common problems that can arise using the appliance. If the
problems cannot be solved with the information below, please call the freephone number or
contact an Authorised Assistance Centre.
Problem
The appliance does not go on.
The plate temperature LED (14)
goes on and off.
A little smoke comes out of the
appliance when it is switched on
for the first time.
Impurities come out of the plate
(15).
The appliance does not produce
steam.
The boiler cleaning LED (10)
continues to flash even after it has
been cleaned.
The plate (15) is dirty: there are
impurities or limescale residues
16

END OF USE

TROUBLESHOOTING

Possible cause
The household appliance is not on.
Normal procedure.
This is absolutely normal and is due to the
expansion of the plastic material.
This cannot happen with a new iron.
The appliance is not on.
The steam button (16) is not being pressed.
There is no more water in the reservoir (1)
and the no water LED (11) is on.
The water reservoir (1) is not positioned
correctly on the boiler and the no water
LED (11) is on.
The ECO button (8) was not held
down long enough.
You are using dirty water or perfumed
substances.
The impurities or chemical substances
found in the water have deposited on the
plate.
You are ironing at a temperature that is
too high.
An excessive amount of limescale and
minerals has accumulated in the boiler.
Solution
Make sure that the appliance is properly
connected to the socket, that the ON/OFF
button (6) is pressed and the light is on.
The switching ON and OFF of the LED (14)
indicates the heating phase of the iron. The
LED goes off once the set temperature is
reached.
This no longer occurs after a while.
These particles are completely harmless
and will disappear after the iron is used a few
times.
Press the ON/OFF button (6).
Keep the steam button (16) pressed as you
iron.
Fill the water reservoir (1) (see chapter:
FILLING THE REMOVABLE RESERVOIR).
Position the reservoir by making it slide on the
guides until it clicks into position.
Hold the ECO button (8) down for at least 3
seconds until the LED goes off.
Empty the reservoir and refill it with clean
water (see the FILLING THE RESERVOIR
chap.).
wait for the plate to cool down and clean it
with a damp cloth.
wait for the plate to cool down and clean it
with a damp cloth.
Clean the boiler (see the CLEANING THE
BOILER chapter).