[D] Electrical Connections; [E] Stacking Condenser Units - Hoshizaki IM-240DNE Notice D'installation

[d] ELECTRICAL CONNECTIONS

This remote condenser unit requires an earth that meets the national and local electrical code requirements.
To prevent possible severe electrical shock to individuals or extensive damage to equipment, install a proper earth wire to the
icemaker and ensure continuity to the condenser.
* Connect the three-wire cord for the fan motor wiring inside the junction box of this condenser unit.
* Usually an electrical permit and services of a licensed electrician are required.
1) Remove the unit cover of the remote condenser.
2) Remove the junction box.
3) Put the three-wire cord through the bushing.
4) Put the three-wire cord through the junction box's grommet. Connect the
fan motor leads and the three-wire cord using closed end connectors and
bind the grommet using a cable tie. After connection, check if the closed end
connectors are faced upward.
5) Secure the three-wire cord in position using the cord grip.
6) Attach the unit cover of the remote condenser.
Fun Motor Lead
(green/yellow)
Fun Motor Lead
(black)
Fun Motor Lead
(blue)
Cable Tie
Connect with closed
end connectors (CE-2)

[e] STACKING CONDENSER UNITS

1) Secure the lower condenser unit.
2) Remove the top panel of the lower condenser unit. Keep the four screws for the top panel.
3) Attach the upper condenser unit on top of the lower.
4) Secure the upper condenser unit with the four screws for the top panel.
5) Install refrigerant lines, and make electrical connections for each fan motor.
WARNING
THIS APPLIANCE MUST BE EARTHED
Junction Box
Grommet
Fun Motor Leads
Bind with cable tie
Three-Wire Cord (17AWG)
9
Unit Cover
Connect with closed
end connectors (CE-2)
Junction Box
Secure with
nylon clamp
Three-Wire Cord
ENGLISH
Remote Condenser
Junction Box
Top Panel
Top Panel