Product And Package Contents; Preliminary Warning Notices; Initial Operations, Safety Instructions - Laserworld Club CS-2000RGB FX Mode D'emploi

1.

Product and package contents

Please check if all listed parts are included and undamaged. Included in delivery:
Laser system, power cable, keys, interlock bridge plug, manual
2.

Preliminary warning notices

• Please use this device only according to these operating instructions.
• Do not use the device if there are any visible damages on housing, connector panels, power
supplies or power cords.
Never look directly into the light source of a laser projector. Danger of damage to the eyes
•
or even blindness in extreme circumstances!
• This device must not be permanently connected to mains. Disconnect it from mains or use
the power button to switch if off if not in use.
• Do not operate the device at high humidity, in the rain or in dusty environments.
• Protect device against dripping or splashing water. Do not place any liquid filled containers near
to this device.
• Any warranty claims are void if the warranty label is removed or tampered with in any way.
3.

Initial operations, safety instructions

• Make sure to use correct voltage; see information on device & in this manual.
Make sure that the device is not connected to mains during installation.
•
• Installation has to be done by technical experienced and qualified persons according to
safety regulations of the respective country.
• Always ensure that maximum permissible exposure (MPE) is not exceeded in areas ac-
cessible to the public or members of staff.
• In some countries an additional inspection by technical control institutes could be necessary.
• Connect an easily accessible interlock connector or circuit breaker to the projector.
• The power supply should be easily accessible.
• When installing the laser mount it with a minimum distance of 15 cm from walls and objects.
• For safe setup e.g. on walls or ceilings please use a safety cord. The safety cord should be able
to withstand tenfold the weight of the device. Please follow the accident prevention regulations of
professional associations and/or comparable regulations for accident prevention.
• If the device has been exposed to great temperature changes, do not switch it on immediately.
Condensation (or any moisture / water formed) may damage device.
Never use dimmer, RC or other electronically switched sockets. Whenever possible, do not
•
use the laser projector together with large appliances (especially fog machines) on the same
mains!
• Ensure sufficient ventilation and do not place the device on any warm or heat radiating sur-
4 / 46
Laserworld CS-2000RGB FX