Stand-Alone / Auto; Master-Slave - Laserworld Club CS-2000RGB FX Mode D'emploi

Laserworld CS-2000RGB FX

8.2.2. STAND-ALONE / AUTO

Stand-alone or Auto operation allows to random playback the internal patterns.
They are played back according to the internal system settings.
Select „AUto" by navigating with the „Up" / „Down" buttons and confirm with „Enter":
Standard selection is „All", which means that all patterns saved on the main board are played
back. You can decide to use only a certain part of the pattern set with a certain grating by selecting
L001, L002, L003, or no grating with L004:

8.2.3. MASTER-SLAVE

The CS-2000RGB FX is Master-Slave capable. This means that the Master laser system can hand
on a control signal to one or more Slave lasers, so all do the same.
Master-Slave only works with lasers of the same product series of the same product generation.
A: Link lasers with DMX cable
To use Master-Slave operation, link the Master with the Slave lasers with DMX cables. Make sure
to use the „DMX out" port on the Master and the „DMX in" on the Slave lasers. If several Slave
lasers are used, link the first one to the Master laser and daisy-chain the control signal from the first
Slave laser to the second etc..
B: Activate Master Laser
The Master laser needs to be set as control source.
Select „SEt" by navigating with the „Up" / „Down" buttons and confirm with „Enter":
Use the „Up" / „Down" buttons to navigate to „uASt"
9 / 46