Working On The Device; Service Notes - Laserworld Club CS-2000RGB FX Mode D'emploi

Laserworld CS-2000RGB FX
face. Especially the ventilation openings must not be covered!
Ensure that device does not get overheated. Make sure that the device is not exposed to
•
spotlights (especially moving heads). Heat of spotlights could overheat laser in a little while and
leads to a degradation of performance.
• This unit is intended for indoor use only.
4.

Working on the device

• This product has no user serviceable parts inside and should only be maintai-
ned and serviced by a qualified engineer.
• Be sure that the mains plug is not connected to the power supply while
installing.
• Take off all reflecting things like rings, watches etc. before starting to
work with or at the projector.
• Only use non-reflecting tools to work on device.
• Wear protective clothing (like glasses, gloves etc.) according to laser
power and wavelength of the laser.
5.

Service notes

• Moisture and heat can reduce lifetime of the laser system dramatically and expires any warranty
claim.
• Quick on/off switching of this device will reduce durability of the laser diode dramatically.
• Avoid sharp knocks and shocks to this device and ensure sufficient protection during transporta-
tion. Look after your Laserworld product.
• To increase durability of your laser, protect device against overheating:
• Always ensure sufficient ventilation.
• Do not face spotlights (especially moving heads) to the device.
• Check temperature after approx. 30 minutes with each new installation. If necessary install the
projector at a place with different temperature.
• Keep the device dry. Protect it from moisture, rain and damp.
• Switch off device when it is not needed. Diodes are switched on and can wear out even if there
is no visible laser output.
• Please ensure the fans and heatsinks are clear from dust and debris otherwise the risk of over-
heating may occur. If the unit and airways appear to be blocked then please contact a qualified
service engineer to maintain and service the product.
• The devices of the Club Series are not meant for professional applications. They are not suitable
for 24/7 operation.
• Removal of the warranty label as well as damages to the device caused by improper
handling, neglect of the safety instructions and service notes will void the warranty
5 / 46